AEM Electronics Dyno-Shaft Sportsman Series
AEM 30-4803 Dyno-Shaft Sportsman Series. Spline & Seal: 27 on 28 spline, 1.597 Seal Diameter. Transmission: Ford 4R70W, 4R70E, 4R75W. U-Joint: Uses 1330 SERIES U-Joint!
AEM uses a set of laboratory-grade strain gauges inside of a supplied calibrated slip yoke to measure Torque at the driveshaft. Essentially, the Dyno-Shaft slip yoke assembly becomes the sensor for measuring driveshaft Torque. This is combined with a driveshaft speed sensor to precisely measure the rotational speed of the yoke to determine RPM. The combination of real Torque and RPM readings allow the Dyno-Shaft to output Torque and Horsepower numbers as accurately as any dynamometer but in a more useful setting, and eliminates all of the inaccuracies associated with accelerometer or GPS based systems.
The data broadcast device (Controller) for the Dyno-Shaft yoke is non-contact, does not have slip rings, does not require batteries and is maintenance free. This Controller installs over the transmission tail shaft housing and allows information from the Dyno-Shaft to be transmitted via AEMnet (AEM's CAN bus communications network) to a data logger, AEM or other programmable engine management system or custom dash.
Images used may be generic. Actual product may vary.
*** Item has been discontinued ***
Product Reviews and Ratings
This product has no reviews at the moment.
Have a review for this product? Sign in to leave a review