You are here: Home • Power Upgrades • Blow off Valve • FRS S13 SR20DET Hotpipe with HKS SSQV Flange
FRS S13 SR20DET Hotpipe with HKS SSQV Flange
|
|
|
Product description Vehicle Applications Customers also bought... |
|||||||||||||||||||
Product Description
FRS S13 SR20DET Hotpipe with HKS Flange. This pipe is an aluminum hot pipe with a HKS Flange attached to it for those who plan to install a HKS Blow Off Valve on the hot side of the engine bay. The use of aluminum pipping offers increased durability, consistent higher boost pressure, improved response and an attractive appearance. The flange fits HKS SSQV blow off valves perfectly. Kit comes with the hotpipe and flange only. A perfect upgrade for those who plan to run a aftermarket blow off valve.
Part #: FRS_HKSFlangeHP
FRS S13 SR20DET Hotpipe with HKS Flange. This pipe is an aluminum hot pipe with a HKS Flange attached to it for those who plan to install a HKS Blow Off Valve on the hot side of the engine bay. The use of aluminum pipping offers increased durability, consistent higher boost pressure, improved response and an attractive appearance. The flange fits HKS SSQV blow off valves perfectly. Kit comes with the hotpipe and flange only. A perfect upgrade for those who plan to run a aftermarket blow off valve.
Part #: FRS_HKSFlangeHP
This product will work for the vehicles listed below. If the model, trim, or years are not listed, then the product will work for any vehicles within the make, model, or trim (respectively). Some products may require modifications to your vehicle.
Vehicle Applications
1989 - 1998
Nissan
180SX
(S13) L4 2.0L SR20DET
1989 - 1993
Nissan
Silvia
(S13) L4 2.0L SR20DET
|
· Dual Stage Pull Type · Ultra Quick Activation · Redesigned version · Opens at 62C degrees · Cools down engine dramatically · Recommended upgrade with swap · Dual Stage Pull Type · Ultra Quick Activation · Redesigned version · Dry 3 Layers · For 200mm HKS filters · Restore fresh air to engine · Dual 12 inch puller style · Can move up to 2,500 CFM · Low profile, includes hardware · Increase steering feedback · Replace old rubber bushings · Recommended to do w/ tie rod · Mounts on suspension tower · Easy oil changes · Full bolt-on kit |
| will pipe work with a front mount intercooler submitted on Dec 10, 2007 |
| Yes, this pipe will work with a front mount intercooler as long as it is made it for your chassis & motor. |
If you have images of this product installed on your vehicle, log in to submit them so others can see your ride!
No customer install images available.
No customer install images available.




